FMC/FME Micro-Channel Condenser Reliable Aluminium Alloy Aluminum
Extruded Pipe 0395
Product description:
A novel form of micro-channel heat exchanger known as FMC/FME was
created to address issues with condensation and frost melting water
that are challenging to remove from traditional single-cooling
parallel flow (PFC) systems, as well as uneven distribution of the
refrigerant gas-liquid two-phase system. These systems are not
designed to address the issue of heat pump air conditioners that
perform both evaporation and condensation.
Multiple refrigerant distribution programme
The header tubes at both ends and the partition plate in the middle
divide the porous flat tube into several zones, the refrigerant
flows back and forth in each zone to form a
condensation/evaporation circuit, and each zone arranges a
different number of porous flat tubes in parallel in the direction
of gravity depending on the state of the refrigerant in the
two-phase and the demand for heat exchange.
The refrigerant distribution scheme is tailored to specific system
characteristics and requirements.
Features:
Reliability
Products for the whole aluminium alloy, compared with copper tube
aluminium fin heat exchanger material between the potential
difference is small, potential corrosion is small, but aluminium
resistance to environmental corrosion than copper is poor, in order
to improve the resistance to environmental corrosion, so as to
comply with the use of air-conditioning products cycle, through the
different aluminium alloys (porous micro-channel tubes, aluminium
fins, the header tube) between the welding bonding part of the
potential design, the priority of corrosion of
non-pressure-resistant parts;
Passivation + hydrophilic coating
improving the overall corrosion resistance of aluminium alloy
materials
Refrigerant application and saving
Can be applied to a variety of refrigerants, high-pressure
refrigerant tube small micro-channel greatly reduces the volume of
the tube, can save refrigerant.
Techical Parameters:
Manufacturing materials-Header
| Fin size | Pitch | Notch |
Φ25×1.5T
| 10.5/7.7
| 20×2.1/20×2
|
Φ32×1.8T
| 10.5
| 25.4×2
|
Φ38×2.2T
| 10.5
| 32×2
|
New Header1
| 10.5/7.7
| 20X2.1/20X2/25.4X2
|
New Header2
| 10.5/7.7
| 20x2.1/20x2/25.4x2
|
Manufacturing materials-Porous micro-channel tubes
| Height/mm | Width/mm | Number of holes |
| 2.1 | 20 | 16 |
| 2.0 | 25.4 | 26/20/13 |
| 2.0 | 32 | 32/13 |
| 2.0 | 20 | 16/15/12 |
Applications:
Household heat pump and air-conditioning condenser;
Commercial multi-line evaporator, condenser;
Commercial heat pump system (module machine) evaporator;
Bus and car air-conditioning evaporator, condenser;
Commercial air-conditioning duct machine evaporator;
Electric locomotive, rv, truck, engineering vehicle condensers,
evaporator;
New energy vehicle air conditioning condenser, evaporator...
Etc.
